Lesson Exam

Quiz Summary

0 of 10 Questions completed

Questions:

You have already completed the quiz before. Hence you can not start it again.

Quiz is loading…

You must sign in or sign up to start the quiz.

You must first complete the following:

Results

Quiz complete. Results are being recorded.

Results

0 of 10 Questions answered correctly

Your time:

You have reached 0 of 0 point(s), (0)

Current
Review
Answered
Correct
Incorrect

Question 1 of 10

1. Question
Which statement is correct?
- Thickness is an important dimension for 303 stainless steel products
- Bar with diameter requirements 0.900 – 1.100” has wider tolerance than bar with diameter requirements 0.994 – 1.006
- Martensitic alloys comprise the largest number of alloys commonly available for any product form
- Width is an important dimension for tube and pipe
Correct

Incorrect
Question 2 of 10

2. Question
Which statement is correct?
- Sheet, strip, and plate are available only as hot-rolled
- Sheet #2B finish is shinier than #3 finish
- Sheet is available cold-rolled + annealed
- The difference between sheet and strip is the metal thickness
Correct

Incorrect
Question 3 of 10

3. Question
Which statement is false?
- Increasing the range of thickness variation corresponds to closer tolerance
- Sheet and strip thickness is indicated in inches, millimeters, and gauge
- Strip is material that was slit from a coil of sheet
- As metal thickness decreases, thickness gauge number increases
Correct

Incorrect
Question 4 of 10

4. Question
Which processes can be used to cut circles from sheet, strip, and plate? Select all correct responses.
- Shearing
- Plasma cutting
- Saw cutting
- Slitting
- Blanking
Correct

Incorrect
Question 5 of 10

5. Question
Which processes can be used to cut thick plate? Select all correct responses.
- Slitting
- Saw cutting
- Plasma cutting
- Laser cutting
- Water jet cutting
Correct

Incorrect
Question 6 of 10

6. Question
Which statement is false?
- Bar is available as round, square, hexagonal, and flat
- Cold-finishing is used to increase metal strength
- Martensitic alloys are available in the hardened condition
- Bar and wire are commonly annealed (with and without additional processing)
Correct

Incorrect
Question 7 of 10

7. Question
Which of these applies to seamless tubing and pipe?
- Made from steel sheet
- Normally available in the hot-finished condition
- There are weld flash requirements
- Wider dimensional tolerances than welded tubing and pipe
Correct

Incorrect
Question 8 of 10

8. Question
Which statement is incorrect?
- For any particular NPS designation, 40S wall thickness is thicker than 10S wall thickness.
- Flash is always removed from the OD of welded tubing
- Pipe finish with 160 grit is shinier than pipe finish with 140 grit
- OD and length are the only important dimensions for tubing and pipe
Correct

Incorrect
Question 9 of 10

9. Question
Which statement is correct?
- Standards include requirements for alloy composition, tensile properties and hardness, and dimensional tolerances
- For each type of product, there is one main standard that applies to the product
- Standards provide information about how products should be used
- The same standards apply to bar, tube, and pipe
Correct

Incorrect
Question 10 of 10

10. Question
Which statement is false?
- 304 is a common stainless alloy
- Duplex is one of the families of stainless steel
- Bar is available only as round
- Sawing is a common service center process
Correct

Incorrect

MetalLearn® – Stainless Steel Products

Quiz Summary

Information

Results

Results

Categories

1. Question

2. Question

3. Question

4. Question

5. Question

6. Question

7. Question

8. Question

9. Question

10. Question